Daily Management And Use Of Plastic Cable Drums:

Apr 15, 2024 Leave a message

1. In the cable plastic cable drum, each process must be used to use a large amount of board tools. The board tools must be passed through inspection, and unqualified board tools must not be used.

2. If the cable plastic cable drum does not need to use all steel plates or plastic plates in each process for product turnover. When the product is delivered, use the corresponding disc according to the customer's requirements.

3. During the process of each process process, the diameter size of the chosen disk and tube shall not be smaller than the minimum bending radius allowed in the use of the cable conveyor. The highest part of the wire core shall not exceed the height of the coil side plate.

4. The turnover board used by the company must have a unified number and board in order to query and use in the production process. Do not use a unified number plate.

5. When leaving the factory, the cable plastic cable drum should indicate the rotation direction of the disc.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry