How to pay attention to the details of the steel cable drum during the transportation process

Mar 16, 2024 Leave a message

We know that there will be more or less problems during the transportation process of steel cable drums. These problems will cause quality instability at a certain time. These situations, in a certain time, especially in the process of transportation, we will be in the process of transportation. Note that such problems cannot be occurred. The cable disk is not allowed to be built. Flating the cable will be wrapped and loose, and it is also easy to damage the cable and the cable disc. Power cables are generally entangled on the cable disk for transportation, storage, and laiding. Short -segment cables below 30m can also roll as circles according to the*small curved radius allowed by no less than the cable, and carry at least tightly after tightness. The past cable disks of cables, mineral cables are mostly wooden structures, and now are mostly steel structures. Because the steel structure is relatively strong, it is not easy to damage. It is good for protecting the cable. And this cable plate can be repeatedly used. Essence In the process of transportation,*important is to protect the cables, and these reasons cannot be caused by the cable.

In the process of transporting and loading and loading cable disks, the key problem is not to cause cables to be damaged, and do not damage the insulation of the cable. Although this is a well -known problem, it often happens, so it should attract enough attention.

The cable disk is generally used in a crane. When the cable disk is transported on the car, the foot therapy should be stabilized and fixedly fixed. The edge of the cable should be stuffed to prevent the cable steel cable drums, collide with each other, or dump each other. Cable must be checked before transportation, the cables should be intact, and the cable seal should be tight; the oil pipes between the inner and outer end of the cable and between the oil -supply cable and the pressure box should be fixed on the plate to avoid being subject to being subject to being subject to the transportation process. The shock is loose; the fuel supply valve on the pressure box should be opened, and the pressure indicates normal; the outside of the cable should be protected to prevent external object damage. If the problem is found, you should handle it before you can install it.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry