1. Before transportation, you should check whether the cable packaging is intact, whether the cable qualification certificate is standardized, whether the cable end is tightly sealed, and firmly fix it on the steel cable drum, whether the steel cable drum side plate is loose and falling off, confirm the confirmation Only after no problem, you can transport it.
2. When unloading the truck, if there is no lifting equipment, the steel cable is strictly prohibited to push directly from the transport vehicle. Because it is pushed directly, not only the steel cable drum is destroyed, but the cable is also prone to mechanical damage. Smaller steel cable drums can be used as a slope with wooden boards, and then pulling the drums of the steel cable with twisted or ropes to slowly roll down the slope.
3. Steel cable drums are not allowed to be built -in vehicles. Flating the cable will be wrapped and loose, and it is also easy to damage the cable and steel cable drums.
When loading, a forklift (forklift) or crane should be used. Several cables should be suspended at the same time. If you hang it in this way, the cables are unevenly stamped, the center of gravity is unstable, and it is prone to slipping and turning.
The drum edge of the steel cable that has been installed on the car should be stuffed to prevent the drums of the steel cable from shaking, colliding with each other or dumping each other. Do not throw it when transporting the power cable when transporting. Put it lightly during transportation. Pay attention to avoid mechanical damage. The soft line of the circle can be stacked or transported in the container when transporting. The palletal height should not be too high. The stacking should be tightly contacting or good fixed measures to prevent the stacked collapse and damage the cable.
4. Rolling the steel cable drum. The steel cable must be controlled within a small distance when the steel cable is rolled on the ground. The rolling direction must be shown on the side of the drum on the steel cable. If the reverse scroll, the cable will be retreated and loose and fall off. After the cable is transported to the destination, it should be checked in time to see if there are cable damage. If there are cable damage, etc., you should immediately contact the manufacturer. , To prevent adverse consequences.
Important engineering cables or export cables. The steel cable drums should be nailed with protective seals. The protective sealing board is best to fix it with the cable bag. Protection.
5. When the cable is installed, the end should be sealed reliably. The end of the cable outside the plate should be added with a protective cover (hat). When transporting, you should pay attention to the drum side of the steel cable to have a certain gap to prevent the bad cable of the card.